Chery automobile Service Manual page 261

The connection between the lower
control arm of the suspension and the
steering knuckle is clearance fit.
Loosen the joint bolt, move the wheel
and adjust the camber.
Check the front wheel toe-in
Toe-in (general)
Car No.
Front wheel toe-in
Tightening torque of toe-in: 55±5N•m.
Adjust the toe-in
Optical tester or mechanical toe-in adjuster can be used to adjust the toe-in.
According to the tester's requirement, make the wheel alignment well before the
adjustment;
Loosen the lock nut and the elastic cover snap ring of the right steering tie rod, and
then screw the toe-in adjusting rod till the length of the rod reaches the specified
value.
Tighten the lock nut and reinstall the elastic cover snap ring. Check whether the lock
nut is tightened enough and cover is in the correct position.
After adjusting the front wheel toe-in, check whether the steering wheel is level. If not,
loosen the lock nut of steering wheel, and then adjust to the level position. The
tightening torque of the steering wheel lock nut is 55±5N•m as required.
Chery A15LHD
0'±10'
M-12