Chery automobile Service Manual page 78

——To take the seal ring out, and replace it if it being
worn and torn.
——To demount the gasket from the thermostat chassis.
To replace with new gasket if it is worn and
torn, and allow no repeated use.
——To measure the thermostat opening temperature
under hot water.
Assembly:
——To clamp the thermostat and then put the gasket
into the thermostat aperture.
——To install thermostat (the side with spring facing
outward).
——To embed spring clamp to ensure the clip within
the thermostat chassis slot;
——To mount new gasket onto thermostat chassis;
——To mount the thermostat chassis and thermostat
assembly into the aperture at the rear side of engine
cylinder head, and screw up the bolt by hand to
9—12N.m.
E-8