Chery automobile Service Manual page 101

counter-clockwise, slowly bring forward fuel
pump assembly.
Pull out fuel level sensor with little upwards
strength.
Installation of accelerator cable:
Install rubber jacket on vehicle front
boarding.
Thread accelerator cable through rubber
jacket, then push it to right position.
Install hook of accelerator cable in gluey
block of accelerator pedal.
Install the other end of accelerator cable on
throttle valve rocker of throttle valve body.
Adjust degree of tightness of accelerator
cable, located by locating clamp.
Caution
·When adjusting degree of tightness of
accelerator cable you should ensure
that: Accelerator pedal doesn't need
any part of empty stroke at idle; when
throttle is full open, accelerator pedal
limiting screw assembly is effective
(accelerator
accelerator
assembly).
Adjusting of accelerator cable:
Range of free travel : 1.0 3.0mm
pedal can step
pedal limiting
F-18
on
screw