Draw the cam shaft assembly out from the rear end
of the cylinder head and be careful not to damage
the cam shaft hole of the cylinder head during this
process.
Inspection
Check whether there is any abrasion on the cam
and the journal of the cam shaft. Change the one
with serious abrasion.
Change the thrust space if the axial clearance of
the cam shaft is above the specification.
Measure the bore diameter of the cam shaft of the
cylinder head or check the relative displacement of
the journal and bore with the cam shaft. Change the
cam shaft if the bore is excessively wore.
Cam Height
Engine model
480
480E
Admission cam T (unit: mm)
38.602
37.559
B-26
Exhaust cam T (unit: mm)
37.586
37.559