Process For Anti-Corrosive Protection Layer - Chery automobile Service Manual

must not exceed 80 .
In the process of welding, the following measures must be taken to prevent the vibration of
the electronic devices.
1. Directly connect the earth wire of the electronic welding device to the welding point.
Attention must be taken to inspect the connection, and ensure that there is no unnecessary
part or insulation part in between the earth wire terminal and spot welding point.
2. ECU shall be removed first. The electronic device or electrical circuit should be avoided to
make contact with the earth wire terminal or welding rod.
RECTIFICATION:
The car body and chassis are produced in the production line through low temperature
tempering, and cold state of casting technology.
Therefore, when part of the metal is damaged in the accident, similar technology must be
used to return to its shape and heating is strictly not allowed.
If it is too damaged to return the original shape the damaged part should be removed after
rectifying the surface of terminal.

PROCESS FOR ANTI-CORROSIVE PROTECTION LAYER

Surface Coating
Intermediate Coating
Paint Filler (Putty)
Electrophoretic Primer Coating
Zinc Phosphate Coating
Steel Plate
The Structure of Paint Spraying
S-41