Assembly - Chery automobile Service Manual

Assembly:

The assembly of the transmission is in reverse
of its disassembly, pay attention to the below
items:
1. Assemble differential assembly on clutch
housing, at first do not assemble output flange.
2. Assemble output shaft and output shaft front
bearing plate, plug into fixing bolt and fasten
by 40Nm moment.
3. Assemble thrust shim needle bearing. Pay
attention to the direction of the thrust shim, the
inside diameter of thrust shim A should be
integrate closely with the bearing holder. Pay
attention that don't mix up the 1st and 2nd
synchronizer ring, 1st synchronizer ring is not
sprayed molybdenum and has three gears
missing.
The side with gears A towards 1st driven gear
B when you assemble the 1st and 2nd
synchronizer.
Assemble reverse gear idler and idler shaft
onto clutch housing.
J-21