Chery automobile Service Manual page 45

Pries the rear oil seal out of the rear oil seal
support with a chisel or a screwdriver. Note: do
not damage the rear oil seal support.
Installation
Put the support on the vice clamp whose jaw
has a piece of wood.
Make the side with the part numbers of the rear
oil seal outward and align the rear oil seal with
the rear oil seal support bore. Press the rear oil
seal into its support with a vice clamp, with the
clearance between the rear oil seal and oil seal
support bore to be 0.26 0.50mm.
Install the new rear oil seal support gasket.
Install the rear oil seal assembly. Before
assembling, wrap a piece of plastic plate on the
crank shaft to avoid colliding the oil seal. And
apply some motor oil on the oil seal edge and
oil seal journal.
Measure the out-of-flat of the bottom plane of
the rear oil seal bracket and the sump flange
surface of the cylinder block, which shall be
within the range of
Tighten the 4 M6 bolts to a moment of
8.0-11.0Nm.
Take away the plastic tape.
0.26mm.
Bolt: M6*20(4 pcs)
Tightening torque: 8~11Nm
B-24
Seal
washer