Sat Control Set; Satellite Receiver Control Setting - JVC DR-MH30S Instructions Manual

Satellite Receiver Control Setting

Your unit
Transmitter
Satellite receiver
21-pin SCART cable
(provided)
Back of unit
L-2 IN/DECODER
ENTER
Satellite receiver
Satellite Controller
(provided)
(suggested locations)
Satellite Controller
(provided)
SAT CONTROL
CABLE/SAT
TV DVD
rtwe
SET UP
The following procedure is required if you receive satellite channels
through a satellite receiver. Approximately 20 seconds before the
S V timer programming (
HOW IEW
programming ( pg. 46) starts, the unit sets its input mode to "L-2"
and automatically switches the satellite receiver's channels using
the provided Satellite Controller.
Installing Satellite Controller
1
Place the Satellite Controller so that the path between its
transmitter and the satellite receiver's remote sensor is
unobstructed.
2
Fix securely using the adhesive strip attached on the back of the
Satellite Controller.
3
Be sure to connect the unit's L-2 IN/DECODER connector to the
satellite receiver's 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its instruction manual.
4
Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
Setting Satellite Receiver's Brand And Channel
After installation, set the satellite receiver's brand and channel
correctly; otherwise, the Satellite Controller cannot work correctly.
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.
1
Turn on the satellite receiver's power.
2
Press SET UP to access the Main Menu screen.
3
Press w e to select "INITIAL SET UP", then press t.
4
Press w e to select "TUNER
SET", then press t.
5
Press rt w e to select "SAT
CONTROL SET", then press
ENTER.
6
Press rt to select "BRAND",
then press ENTER.
7
Press rt to select the brand
code from the list on page 24, then press ENTER.
● If the unit is in playback or recording mode, you cannot set the brand
code.
8
Press rt to select "PROGRAMME", then press ENTER.
9
Press rt to select one of the channel positions on the satellite
receiver, then press ENTER.
● You can select the channel position between 1 to 999.
10
Press rt to select "TEST",
then press ENTER. The unit enters
the Test mode.

SAT CONTROL SET

EN
pg. 44) or Manual Timer
DVD VIDEO SET UP HDD/DVD SET UP FUNCTION SET UP INITIAL SET UP
TUNER SET CLOCK SET
AUTO CH SET MANUAL CH SET
SAT CONTROL SET GUIDE PROG SET
11
12
13
SET UP ENTER
SELECT WITH [ ] THEN PRESS [ENTER]
PRESS [SET UP] TO EXIT
EXIT
SELECT
INITIAL SET UP > SAT CONTROL SET
BRAND 73
PROGRAMME 12
TEST
SET UP ENTER
SELECT WITH [ ] THEN PRESS [ENTER]
PRESS [SET UP] TO EXIT
EXIT SELECT
23