SATO TG3 Series Operator's Manual page 13

1.3 PARTS IDENTIFICATION (cont'd)
Internal view when Main cover is opened (Front view)
10
11
12
13
14
15
10 Ribbon take-up spindle (coreless)
Used to wind up the used ribbon without using
core.
11 Print head assembly
This component is used to print on the media.
Perform maintenance at regular intervals.
12 Cutter assembly
This assembly consist of cutter as well as the
cutter sensor assembly.
TG3 Series Operator Manual
13 Head balance adjustment knob
To adjust print head balance to obtain
consistent print out across media.
14 Head Alignment adjustment knob
To adjust print head alignment to obtain
consistent print out across media.
15 Head lock lever
Used to open and close the print head.
Section 1: Introduction
Page 1-5