SATO TG3 Series Operator's Manual page 18

Section 2: Installation
2.3 LOADING MEDIA (cont'd)
3.
If the inner diameter of the roll is 100 mm (4"), attach the
supplied boss at the roll media supply spindle. If the
inner diameter of the roll is 75 mm (2.95"), proceed to
Step 4.
Using the boss attachment positions given in the follow-
ing table as a guide, attach the boss and then fasten it in
place with the screws provided. Attached the screws on
both opposite side of the boss.
Boss attachment position
Attachment hole 1, 2
Attachment hole 2
Attachment hole 3
4.
Load the media to the roll media supply spindle.
Make sure the media leader is pull out from the bottom
and the printed side is facing upwards. Push the roll
firmly towards the end of the spindle.
5.
Attach the roll media guide back and make sure that
the roll media guide pushes snugly against the media
roll to prevent media drift during printing.
Page 2-4
Media width
Up to 40 mm (1.6")
Up to 50 mm (2")
50 mm (2") to 80 mm (3.1")
3
2
boss
Roll media
supply spindle
Printed side should
face upward when
feed in to printer.
TG3 Series Operator Manual
1