Cut Offset Adjustment In Service Mode - SATO TG3 Series Operator's Manual

3.15 SERVICE MODE (Cont'd)

3.15.3 Cut Offset adjustment in Service Mode

FUNCTION
button
Return to SERVICE MODE menu
Menu
TG3 Series Operator Manual
Select CUT OFFSET +
FEED button
ONLINE button
FEED button
CUT OFFSET MODE
Adjusting cut offset for each type of media.
Select a media type with
Use / arrow buttons to enter adjusted value.
"+" for moving the cut position forward.
"-" for moving the cut position backward, against paper feed direction.
The adjustment range is between ± 00 and 99 dots.
For the initial value of each media and model, refer to the chart below.
Media
Tag
Label
Others
Section 3: Configuration and Operation
* Press , , or button to select
item or set the value accordingly.
The active arrow icons are displayed
on the screen.
Description
/ arrow buttons.
Sensor
Center hole
Side hole
Edge
I-Mark
Gap
I-Mark
Not sensor
TG308 TG312
+00 +00
+00 +00
+00 +00
-12 -18
-12 -18
-36 -54
+00 +00
Page 3-45