Rs232C High Speed Serial Interface; Rs-232C Serial Interface Card Dip Switch Settings - SATO TG3 Series Operator's Manual

Section 7: Interface Specifications

7.2 RS232C HIGH SPEED SERIAL INTERFACE

7.2.1 RS-232C Serial Interface Card DIP SWITCH Settings

The high-speed serial interface card (optional) contains DIP switches for controlling communication
conditions. Determine what features are applicable to your setup, or desired setup, and adjust their respective
DIP switches as applicable.
There are 8 switches in a row and all are default setting at Off position. The DIP switch functions are as follow:
DIP switch No.
1 Data bit length
2
Parity setting
3
4 Stop bit setting
5
Baud rate setting
6
7
Communication
Protocol setting
8
Function
Data bit length
Parity setting
Stop bit setting
Baud rate setting
Communication Protocol
setting
Page 7-2
Function
DIP sw 2
ON
ON
OFF
OFF
DIP sw 5
ON
ON
OFF
OFF
DIP sw 7
ON
ON
OFF
OFF
FUNCTION DESCRIPTIONS
Description
Sets the printer to receive either 7 or 8 bits of data for each byte transmitted.
Selects the type of parity used for error detection.
Selects the number of stop bits to end each byte transmission.
Select the data rate (bps) for the RS232 port.
Selects the flow control and status reporting protocols
Setting Description
ON 7 bits
OFF 8 bits
DIP sw 3
Not used
ON
OFF ODD
ON EVEN
OFF NONE
ON 2 bits
OFF 1 bit
DIP sw 6
57600bps
ON
OFF 38400bps
ON 19200bps
OFF 9600bps
DIP sw 8
STATUS4
ON
OFF STATUS3
ON XON/XOFF
OFF READY/BUSY
TG3 Series Operator Manual