Basic Specifications - SATO TG3 Series Operator's Manual

7.2 RS232C HIGH SPEED SERIAL INTERFACE (Cont'd)
Notes:
• Check the setting seal of the serial interface card.
The correct settings may vary depending on the type and revision of the board.
• The setting range of baud rate and protocol can be changed in the printer's Interface Mode. See Section
3.7 Interface Mode for details.
• Baud rate 2400bps and 4800bps can be set in the Interface Mode of the printer only. STATUS5 for "Proto-
col" can be set in the Interface Mode of the printer only.
• Single item buffer or multi buffer can be set in the printer's Interface Mode when [READY/BUSY] and
[XON/XOFF] are effective.

7.2.2 Basic Specifications

Interface connector
Synchro system
Maximum receive
buffer capacity
Code
Connectors
Transmission form
Signal level
TG3 Series Operator Manual
13
25
Asynchronous method
2.95MB
0MB
Buffer near full
occurred
Buffer near full
released
ASCII (7 bits), Graphic (8 bits)
Printer side DB-25S (male) or equivalent
Cable side DB-25P (female) or equivalent
Cable length 5m and under
Start
b1 b2 b3
[Note] If using 7 bits, b8 will be omitted.
High level : +5 to +12V
Low level : -5 to -12V
Serial Connector Pin Asignments
b4 b5 b6 b7 b8
Section 7: Interface Specifications
1
14
2.95MB
Remaining 0.95MB
Remaining 1.95MB
Stop
Page 7-3