SATO TG3 Series Operator's Manual page 67

3.12 TEST PRINT MODE (Cont'd)
Menu
TG3 Series Operator Manual
TEST PRINT MODE
Setting ink roller motion during test print.
NO: No ink roller action will be taken.
YES: Ink roller action will be taken during test print.
The initial value is NO.
Adjusting the print and cut positions.
Press / arrow buttons to change the setting value and press
buttons to toggle between PITCH POSITION and OFFSET POSITION setting.
Both setting range are ±3.75mm and are adjustable by 0.25mm.
The initial value is +0.00mm.
Press FEED button to start test printing.
Test print is in progress
Press FEED button while printing will pause the test print operation.Press
FEED again to continue.
Section 3: Configuration and Operation
Description
/ arrow
Page 3-37