Shifting Motion Of Base Reference Point - SATO TG3 Series Operator's Manual

8.6 SHIFTING MOTION OF BASE REFERENCE POINT

This is the motion to shift the base reference point of printing or cutting stored in a printer to another point by
the online command ESC #.
This function is used when the # data specified in the item (ESC A ~ Z) before printing is different from the
default value or the #data changed previously.
.
With cutting motion
(i)
Stops after printing
(Stores by #+40)
(ii)
After receiving print data
(Specified by #+000), the
printer discharges the
media remained inside.
(iii)
Backfeed motion
(iv) *2
Shifting cutting and
printing position
(Adjusts the top of form)
(v)
Backfeed motion
*1. For the printer without cutting motion,
discharged.
*2. When the media is not remained inside, it starts from the printer motion (iv).
*3. When [ADJUST FEED ACTION] is set to "CONTINUE" in Advanced Mode, the printer will go online
automatically and start issuing tags after backfeed motion is complete.
#data value is reset when power cycled, and the value changed by the # command will be valid until
shutdown.
Center hole
Type
#data
+040(+060)*
Default value
* The value in parantheses( ) is for TG312 (12dots/mm) printer.
TG3 Series Operator Manual
Cutter
*1
Side hole tag Edge (notch)
tag
+040(+060)*
Printhead
1 will be discharged without being cut, but
I-mark tag
tag
+000
Section 8: Appendix
Pitch sensor
Gap labe
+000 +000
2 will be cut and
I-mark label
+000
Page 8-11