SATO TG3 Series Operator's Manual page 50

Section 3: Configuration and Operation
3.7 INTERFACE MODE (Cont'd)
Menu
Page 3-20
IEEE1284 CONFIGURATION
Setting receive buffer type.
When MULTI and IEEE1284 are selected, the printer will proceed to
PROTOCOL menu.
When 1ITEM and IEEE1284 or CENTRONICS are selected, the printer will
proceed to IEEE1284 ACK SIGNAL menu.
The initial value is 1ITEM.
Select the communication protocol.
STATUS4 and STATUS5 are available for selection when IEEE1284 interface
boards is installed.
The initial value is STATUS4.
When STATUS4 is selected, the printer will proceed directly to IGNORE CR/LF
menu.
When STATUS5 is selected, the printer will proceed to ITEM NO CHECK
menu.
Set item number check function.
ENABLE: Item number check is ON
DISABLE: Item number check is OFF
The initial value is DISABLE.
This screen is displayed only when PROTOCOL is set to STATUS5.
Set BCC check function.
ENABLE: BCC check is ON
DISABLE: BCC check is OFF
The initial value is DISABLE.
This screen is displayed only when PROTOCOL is set to STATUS5.
Set the IEEE1284 ACK signal.
Press / arrow buttons to change the setting value.
Setting range is between 00.5μs and 12.0μs, and settable by 0.1μs.
The initial value is 00.5μs.
This screen is displayed only when RECEIVE BUFFER is set to 1ITEM.
Description
TG3 Series Operator Manual