SATO TG3 Series Operator's Manual page 123

7.6 WIRELESS LAN ETHERNET (Cont'd)
7.6.1 Basic Specifications (Cont'd)
DSW
Interface selection
Communication setup
TG3 Series Operator Manual
DSW is a maintenance switch to initialize the configuration saved on the wireless
LAN board, to print the configuration, and to set wireless LAN communication
mode.
<Important>
1) Make sure to set all the DSW to "OFF" when you use the printer.
2) Make sure to set [DSW1] to "OFF".
DSW
1
2
3
4
Wireless LAN interface and the LAN interface are provided as a combo board.
Turn on the printer without connecting the LAN cable.
The following communication settings are available in the Interface Mode of the
printer.
Item
Protocol
IP address
Subnet mask
Gateway address
Communication mode
SSID
Channel
* IP address, Subnet mask, Gateway address are settable in [Admin Manager],
the utility of attached CD-ROM, and communication mode is settable by the DSW
of interface board. In this case, each setting value is saved to the interface board
directly. Go to [LAN Configuration] of Interface Mode to enable the setup either by
the one mentioned above or by the Interface Mode.
Operation when turning the printer on while DSW is ON
Not used (Setup prohibited)
LAN board EEPROM initialization (Initializing configura-
tion)
Print of self-diagnosis (Prints the examination result of
board on a label)
Print of configuration (Prints configuration details such as
an address)
Wireless mode switching (OFF: Ad hoc / ON: Infrastruc-
ture)
STATUS3
STATUS4 (Cyclic response mode)
STATUS4 (ENQ response mode)
STATUS5
0.0.0.0 ~ 255.255.255.255
0.0.0.0 ~ 255.255.255.255
0.0.0.0 ~ 255.255.255.255
802.11 Ad hoc
Infrastructure
Optional alphanumeric character string
(Up to 32 characters)
01 ~ 14
Section 7: Interface Specifications
Setting range
Page 7-13