Motor Error - Roland VersaCamm SP-540V Service Notes

6-10 MOTOR ERROR

NO CHECKING POINT
1 Media Jam
Broken / life of the
2
Motor
Power Supply
3 voltage for Motor is
not supplied
4 Broken Motor Driver
There is a dirt in
5
teeth of Drive Gear.
Weight of Media
6 exceeds usable
Media.
MOTOR ERROR
< ERROR DESCRIPTION
SCAN MOTOR ERROR
CODE :
< ERROR LIST >
Bit
No.
Feed Motor Deviation Error
0001
Feed Motor Overcurrent Error 1
(Big load is put on the motor movement
0004
Feed Motor Overcurrent Error 2
(A little load is put on the motor
0008
movement for a long time.)
0001 and 0004 occurred at the same
0005
Revised 4
0001 and 0008 occurred at the same
0009
0010 Scan Motor Deviation Error
Scan Motor Overcurrent Error 1
0040 (Big load is put on the motor movement
Scan Motor Overcurrent Error 2
(A little load is put on the motor
0080
movement for a long time.)
0010 and 0040 occurred at the same
0050
Revised 4
0010 and 0080 occurred at the same
0090
ACTION
Remove cause of
Media Jam.
Motor
Replacement
Replace Switching
Power Supply
Mainboard
Replacement
Clean Drive Gear.
Use usable Media.
0000 0000
Record for LAST ERROR
CURRENT ERROR
MEANING
instantaneously.)
time.
time.
instantaneously.)
time.
time.
REFERENCE
When the edges of the media curls or the media
absorbs the Ink and becomes to be irregular
surface of the media, the Head Carriage catches
on the media during printing and results in the
Motor Error.
[3-5 Carriage When the Motor is broken or reaches its life, the
Motor Motor cannot obey the order from the CPU and it
Replacement] results in the Motor Error.
[3-13 SW Power When the Power Supply voltage for the Motor is
Supply not supplied, the Motor cannot move and it results
Replacement] in the Motor Error.
When the Servo Board is broken, the Power
Supply voltage for the Motor is not supplied and
the Motor cannot move. It results in the Motor
Error.
When there is a dirt in the teeth of the Drive Gear
and it cannot rotate, the Motor Error occurs.
When the weight of Media is too heavy, the Motor
Error occurs due to the too much load for feeding
Media.
Display the axis which the Error happens.
< User side >
1. Media Jam
2. Pull or Move the Carriage by hands.
3. Carriage runs into a thing/hands.
4. Media is stuck because the media end is not separated from the
paper tube.
5. Heavy media is used.
< Mechanical Side >
1. There is a bad contact/cut-line in the cable.
2. Screw fixing the tool carriage to wire is shifted.
3. Motor is broken./Life
4. Head/Servo Board is broken.
6-8
OUTLINE
CAUSE