Roland VersaCamm SP-540V Service Notes page 173

Connection
Connecting the Power Cord
Installation of VersaWorks
!! IMPORTANT !!
<System Requirements for Installing the Software>
Operating system : Windows XP ServicePack 1 or Windows 2000 Service Pack 4
CPU : Conputer with Pentium 4 2.0GHz or faster recommended
Memory (RAM) : 512 MB (1 GB or more recommended)
Free hard-disk space required for installation : 100 MB
Free hard-disk space required as a working space : 1 GB or more recommended
Before printing
Set the Voltage Switch
!! IMPORTANT !!
Before switching on the power, set the voltage switch for the region where the machine is installed.
Change the setting for the language and Unit of Measurement.
You can change the setting for the language and the measurement unit used for the LCD by
turning on the Sub Power while holding down [MENU] key.
Fill Ink
!! IMPORTANT !!
2 pcs. of the SOL INK cleaning cartridges are required in this work.
Always be sure to gently shake the ink cartridge before you install it.
Match the machine to the environment where installed. (Perform [ENV. MATCH])
The printing length in scanning direction may change depending on the operating
environment, such as temperature or humidity.
This adjustment is to reduce misalignment between the printing and the cutting in the
scanning direction caused by the operating environment.
Install the Blade
Connect to the Computer
Setup IP Address
Switch the Power On and Off.
!! IMPORTANT !!
Once you have switched on the main power, you should normally leave it on.
In day-to-day use, you switch the machine on and off using only the sub power.
Menu Operations
Neither printing nor cutting is performed while menu settings are being made.
When you have finished making menu settings, press the [MENU] key to go back to the top menu.
7-8