Roland VersaCamm SP-540V Service Notes page 104

SERVICE MENU
SERVO LOCK
This menu is used for checking whether the Servo Motor can perform the Servo Lock.
This menu makes the Servo free.
The value on the LCD changes depending on the head position when you move the carriage left and right
by hand, if the motor feeds back right. When the [ENTER] key is pressed, the Servo Motor will be excited.
SERVICE MENU
DISP SCAN POS
This menu is used for displaying the position of the cutting and printing carriage. The carriage becomes free
in this menu and is able to be moved. The position of the carriage is displayed on real time. The value next to
"M:" shows you the motor position and the value next to "L:" shows you the carriage position. The position can
be re-set by pressing the [ENTER] key and press [
SERVICE MENU
AGING
When the [ENTER] key is pressed, the HEAD CARRIAGE stops Aging and moves back to the locking position.
Make sure not to perform Aging for a long time when the machine is filled with ink to prevent the ink from drying up.
SERVICE MENU
CALIB.DEFAULT
This menu is used for Calibration. Refer to [CALIBRATION].
SERVICE MENU
CROP-TOOL ADJ.
This menu is used for adjusting the position of Tool/Crop Mark Sensor.
Refer to [Tool/Crop Mark Sensor Position Adjustment].
SERVO LOCK
S: 100
SERVO LOCK
F: 0
M: 1000.123 mm
L: 998.222 mm
] to exit the menu.
AGING
SCAN
AGING
FEED
AGING
BOTH
AGING
CUTTING
AGING
CONNECT
CALIB.DEFAULT
TEST PRINT
Distance compensation in feed direction
Prameter is changed by the
Setting range is from -2.0 to +2.0% in 0.02% unit
CALIB.DEFAULT
SETTING
CROP-TOOl ADJ.
TEST PRINT
CROP-TOOL ADJ.
FEED SETTING
CROP-TOOL ADJ.
SCAN SETTING
CROP-TOOL ADJ.
AUTO
CROP-TOOL ADJ.
TEST PRINT 2
SERVO LOCK
S:* 0
SERVO LOCK
F:* 0
SCAN
NOW AGING
FEED
NOW AGING
BOTH
NOW AGING
CUTTING
NOW AGING
CONNECT
NOW AGING
key
SETTING
+0.06% +0.10%
FEED SETTING
-0.15mm -0.23mm
SCAN SETTING
-0.40mm -0.40mm
CROP-TOOL ADJ.
REMOVE CROPMARK
CROP-TOOL ADJ.
COMPLETED
4-7
4