Print/Cut Position Adjustment - Roland VersaCamm SP-540V Service Notes

4-9 PRINT / CUT POSITION ADJUSTMENT (Referential Time : 10min.)
[About PRINT / CUT POSITION ADJUSTMENT]
This adjustment is for calibrating the relative positions of printing and cutting.
If it is not adjusted, it could result in a problem that the cutting shifts from printing.
There are two adjusting ways prepared in this Mode, Manual and Auto.
We recommend to carry out the Manual Adjustment for more accurate adjustment.
Before doing this adjustment, perform [ENV. MATCH].
4
Turn on the sub power switch while pressing [ ], [ ]
1
and [ ] keys to enter the SERVICE MODE.
Set the SVG-G media on the machine and lower the
Pinch Rollers.
Select [SETTING 2] under the [PRINT&CUT ADJ.]
2
menu and press the [
right figure.
Three marks are not printed unless
[TEST CUT] is pressed in the state of a
screen*.
Press the [TEST CUT] key to excute printing the Test
3
Pattern. The marks are printed in the right edge, the left
edge and middle of the media (Three position) and
each frame of the marks is cut.
At this time, if the [TEST PRINT] key is
pressed, the mark is printed in the right edge
of the media (only one position) and a frame of
the mark is cut.
] key to enter the menu in the
[ ], [
Menu
SERVICE MENU
SERVICE MENU
PRINT&CUT ADJ.
PRINT&CUT ADJ.
SETTING2
F: 0.40 ----
S:-0.50 ----
4-40
], [ ] + POWER ON
[ MENU ] key
[ ]