Table of Contents
Advertisement
4-5 LIMIT POSITION & CUT DOWN POSITION INITIALIZE (Referential Time : 10min.)
[About LIMIT POSITION & CUT DOWN POSITION INITIALIZE]
This is used to compensate the distance between the Capping position and the position where the Limit
Sensor is detected. It also detects the distance between the cut down position to the Limit Sensor.
Remove the I/S COVER.
1
Turn on the SUB POWER SW while pressing [ ], [ ]
2
and [ ] keys.
Connect the Tool carriage and Head carriage.
3
Push the HEAD CARRIAGE leftward and check if it is
locked.
If it is locked, proceed to the next step.
If it is not locked, move the HEAD CARRIAGE
rightward until it will be locked.
After the HEAD CARRIAGE is locked, push the
Head Carriage to the left until it stops because there
is a play with the HEAD CARRIAGE.
[
] , [
LIMIT INITIALIZE
MOVE TO CAP POS
4-29
I/S COVER
] , [
] + POWER ON
MENU
4
Hide quick links:
Advertisement
Table of Contents
