Roland VersaCamm SP-540V Service Notes page 122

- When the M lines are above the K lines, turn the
Adjustment Screw CW.
- When the M lines are below the K lines, turn the
Adjustment Screw CCW.
Adjust the M/Y Head on the basis of the K/C Head.
It is not necessary to adjust the K/C Head.
Tighten the screws fixing the Head in the reverse order
16
when fixing with using the TORQUE DRIVER (ST-056).
Torque for tightening is 2kgf • cm (20cNm).
Make sure not to tighten the screws firmly.
Print the test pattern again.
17
If the result is NG, repeat 12 ~ 16 .
The shifting of lines should be within 1/2 dot.
4-25
4