Vehicle Warm-Up; Riding The Vehicle - BOMBARDIER SKI-DOO MX-Z Renegade 600 HO SDI Operator's Manual

VEHICLE WARM-UP

Before every ride, vehicle has to be warmed up as follows.
Snowmobile must be securely supported by the rear bumper using
a wide-base snowmobile mechanical stand. Track must be 100 mm
(4 in) off the ground.
Attach tether cord to operator's clothing eyelet.
Start engine and allow it to warm up two or three minutes at idle speed.
Release parking brake.
Make sure wide-base snowmobile mechanical stand is stable.
Stay clear of the front of vehicle and the track. Do not use too
much throttle during warm-up or when track is free-hanging.
Apply throttle until drive pulley engages. Let track rotate at low speed
for several turns. The lower the vehicle temperature is the longer
vehicle warm-up should be.
Shut-off the engine and remove the wide-base snowmobile mechan-
ical stand.
Skis may be frozen on the ground. Grab both skis one at a time by
their loops and lift their front end slightly off the ground.
After restarting engine, the vehicle can be driven at low speed for the
first 2 or 3 minutes of riding. After that, it may be driven up to the
legal speed limit as per normal safety practices.

RIDING THE VEHICLE

At this point you are acquainted to the specifics of these models of
snowmobile and you are instructed about the control locations and
operation.
Before starting out on your first ride with this vehicle, read the fol-
lowing safety information as you will be informed about the safe op-
erating practices.
Although the mere reading of such information does not eliminate
the hazard, its understanding and heeding of all of the warnings and
cautions will promote the safe use of the vehicle.
Before venturing on the trails, operate the snowmobile in a restricted
flat area until you are completely familiar with its operation and feel
comfortable that you can safely tackle a more demanding task. Have
an enjoyable and safe ride.
106
WARNING