Hitachi Simple Modular Storage 100 User Manual page 74

Symptom
Auto migration or data shredding
operation has failed
An error message appears in Storage
Navigator Modular 2 during auto
migration
The array went down during the auto
migration procedure.
5–8
Table 5-1: Troubleshooting (Continued)
1. If a auto migration or data shredding operation has
2. Confirm that the auto migration cables are connected
3. Confirm that the target array is in migration mode
4. Connect the target array again.
5. Only one migration operation can be performed on an
6. If the problem persists, visit the Hitachi Web Portal at
Please see
suggestions.
1. Move the MAIN SW switch on the back panel of the
2. Move the MAIN SW switch on the back panel of the
3. Remove the migration cable between the source and
4. Move the MAIN SW switch on the back panel of the
If array down condition occurs again when starting the
source array, turn off the source array again and then turn
it on. Check that the READY LED goes ON after a few
minutes. If the READY LED does not go ON after 20
minutes, visit the Hitachi Web Portal at
support.hds.com.
Troubleshooting
Hitachi Simple Modular Storage 100 User's Guide
Suggested Actions
failed, an error message appears in the Error field of
the Array Migration window.
properly.
(MODE switch is in the E position).
array. If the array has already been used as a target
in an array migration, it cannot be used as a target
array again.
http://support.hds.com.
Table 5-2 on page 5-10
source array to the OFF position. Verify that the
POWER LED goes OFF.
target array to the OFF position. Verify that the EXT
and POWER LEDs go OFF.
target arrays.
source array to the ON position and verify that the
POWER LED goes ON.
for troubleshooting
http://