Connecting To The Iscsi Gigabit Ethernet Data Ports - Hitachi Simple Modular Storage 100 User Manual

•

Connecting to the iSCSI Gigabit Ethernet Data Ports

The following procedure describes how to connect the iSCSI Gigabit
Ethernet data ports to your storage network or server. The default IP
addresses for the iSCSI data ports are shown in
can be changed using the Storage Navigator Modular 2 software.
NOTE: If your Hitachi Simple Modular Storage 100 has one controller,
ignore the IP addresses for on CTL1 in
Controller
Controller 0
Controller 1
1. On the back panel, insert one end of an Ethernet cable into an iSCSI data
port (either PORT A or PORT B) on the back of your Hitachi Simple
Modular Storage 100 (see
page
switch.
2. To connect additional iSCSI data ports to your storage network, repeat
step 1 using another Ethernet cable and another available iSCSI data
port.
•
NOTE: If your Hitachi Simple Modular Storage 100 has one controller,
ignore the iSCSI data ports on CTL1 in
•
NOTE: The IP address for your server(s) console must be on the same IP
subnetwork (192.168.0.x) as the iSCSI data ports.
Figure 3-6: Management Ports
Table 3-3: Default iSCSI Data Port IP Addresses
iSCSI Data Port
Port A
Port B
Port A
Port B
3-16). Connect the other end of the cable to your host system or
Installing Your Array
Hitachi Simple Modular Storage 100 User's Guide
Management Port on CTL1
Management Port on CTL0
Table
Table 3-3.
192.168.0.200
192.168.0.201
192.168.0.208
192.168.0.209
Figure 3-7 on page 3-16
Figure 3-7 on page
3-3. These settings
IP Address
and Figure 3-8 on
3-16.
3–15