Hitachi Simple Modular Storage 100 User Manual page 44

•
NOTE: Be sure the rack provides sufficient airflow to the front and back of
your Hitachi Simple Modular Storage 100 to maintain correct cooling.
1. Verify that your Hitachi Simple Modular Storage 100 is turned off.
2. Verify that the MAIN SW switch is in the OFF position.
3. With help from another person, position and hold your Hitachi Simple
Modular Storage 100 in the rack. Then secure the array to the rack frame
using M5×10 binding screws (one screw at the right and left sides of the
array, as shown in
manual for your mounting hardware and rack.
•
WARNING! To prevent bodily injury when mounting or servicing
your Hitachi Simple Modular Storage 100 in a rack, you must take
special precautions to ensure that the array remains stable. The
following guidelines are provided to ensure your safety:
• Perform the rack installation with three or more persons.
• Work carefully because a single Hitachi Simple Modular Storage 100 can
weigh 72.6 pounds (33 kg).
• Your Hitachi Simple Modular Storage 100 should be mounted at the
bottom of the rack if it is the only unit in the rack.
• Lift the array up to the height suitable for mounting. Adjust the position
of the array, so it is seated in the center of the rack frame. Shift the
array onto the rails in the rack frame. When shifting the array, push it in
to the end gently.
• When mounting your Hitachi Simple Modular Storage 100 in a partially
filled rack, load the rack from the bottom to the top, with the heaviest
component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers
before mounting or servicing your Hitachi Simple Modular Storage 100
in the rack.
•
WARNING! During installation, if your Hitachi Simple Modular
Storage 100 falls at a high position, a personal injury will be caused.
Three or more persons are required to installing the array in a rack
above chest level. Perform the positioning, fastening, or other
handlings very carefully.
•
3–10
Figure 3-3). For more information, refer to the
Installing Your Array
Hitachi Simple Modular Storage 100 User's Guide