Drive Slots; Front Panel Leds; Power Led; Ready Led - Hitachi Simple Modular Storage 100 User Manual

Drive Slots

The front panel of your Hitachi Simple Modular Storage 100 has two drive
slots. Each slot can accommodate a spare drive. The spare drive must be of
the same type (SATA or SAS) as the other drives in your Hitachi Simple
Modular Storage 100.

Front Panel LEDs

The front panel has several light-emitting diodes (LEDs) that show the
status of your Hitachi Simple Modular Storage 100.

Power LED

The front panel has a green Power LED that shows when your Hitachi
Simple Modular Storage 100 is turned on and receiving power.
LED Status
ON
OFF

Ready LED

The green Ready LED shows when your Hitachi Simple Modular Storage
100 is ready for operation.
LED Status
ON
Slow Blink
Fast Blink

Alarm LED

The red Alarm LED shows when your Hitachi Simple Modular Storage 100
is operating normally or has encountered a fatal error.
LED Status
OFF
ON
Slow Blink
2–2
Table 2-1: Front Panel Power LED
Hitachi Simple Modular Storage 100 is turned on and receiving power.
Hitachi Simple Modular Storage 100 is not turned on.
Table 2-2: Ready LED
Normal operation; the array is operational.
Downloaded firmware execution procedure is finished (displayed
during maintenance mode).
Firmware is downloading (do not turn off the array).
Table 2-3: Alarm LED
Normal operation
Fatal error. Please visit the Hitachi Web Portal at
support.hds.com.
A serious failure has occurred. Please visit the Hitachi Web Portal at
http://support.hds.com.
Identifying Hardware Components
Hitachi Simple Modular Storage 100 User's Guide
Description
Description
Description
http://