Removing The Oap Card In An Expansion Interface Card Slot; Installing/Removing A Poe Module; Installing A Poe Module; Removing The Poe Module - HP 5800-48G Installation Manual

Removing the OAP card in an expansion interface card slot

See "Removing an interface

Installing/removing a PoE module

You can install a hot swappable PoE module (LSW148POEM) in a 5800-48G-PoE+ (2 slots) or
5800-48G-PoE+ TAA (2 slots) switch to supply power to devices such as IP telephones, wireless LAN
access points (APs), and web cameras through Ethernet ports over twisted pair cable.

Installing a PoE module

1. Wear an ESD wrist strap and make sure it makes good skin contact and is correctly grounded.
2. Loosen the captive screws on the filler panel over the PoE module slot with a Phillips screwdriver
and remove the filler panel.
3. Put away the removed filler panel for future use.
4. Unpack the PoE module.
5. Push the PoE module slowly along the guide rails into the slot (see callout 1 in
the ejector levers inward to lock the PoE module in position (see callout 2 in
Do not use excessive force.
6. Fasten the captive screws on the PoE module with a Phillips screwdriver to securely fix the PoE
module in the slot.
Figure 54 Installing a PoE module

Removing the PoE module

1. Wear an ESD wrist strap and make sure it makes good skin contact and is correctly grounded.
2. Use a Phillips screwdriver to completely loosen the captive screws on the PoE module.
3. Pull the ejector levers outward (see callout 1 in
along the guide rails (see callout 2 in
Do not use excessive force.
card."
2
1
Figure 55). Then pull out the PoE module slowly
Figure 55).
40
Figure 54) and push
Figure 54).