5800-48G-Poe+ (1 Slot)/5800-48G-Poe+ Taa (1 Slot) - HP 5800-48G Installation Manual

Figure 74 Rear panel
(1) AC-input power receptacle
(3) Grounding screw
NOTE:
The 5800-48G (1 slot) and 5800-48G TAA (1 slot) switches come with the expansion interface card slot
•
covered by a filler panel. In this figure, an LSW1SP4P0 interface card is installed in the slot.
These two switches also come with the RPS receptacle covered by a protective cover.
•

5800-48G-PoE+ (1 slot)/5800-48G-PoE+ TAA (1 slot)

Figure 75 Front panel
(1) 10/100/1000Base-T auto-sensing Ethernet port
(3) Seven-segment LED
(5) SFP+ port LED
(7) System status LED (SYS)
(9) Interface card status LED (SLOT1)
(11) Port LED mode switching button
To use the console port and USB port, open the logo plate, as shown in
(2) RPS receptacle
(4) Expansion interface card slot
(2) 10/100/1000Base-T Ethernet port LED
(4) Port mode LED
(6) Logo plate (A console port and a USB port are
under this logo plate)
(8) RPS status LED (RPS)
(10) SFP+ port
68
Figure 72 and Figure 73.