Removing The Idler Pulley; Removing The Idler Pulley Assembly; Removing The Drive Motor; Removing The Burner (Gas Dryers) - Electrolux 27" Electric Dryers Service Manual

Removing the idler pulley:

1. Disconnect the dryer from electrical supply and
remove the rear vent.
2. Release the belt from the motor pulley and slide
the idler pulley off.

Removing the idler pulley assembly:

1. Disconnect the dryer from electrical supply and
remove the rear vent.
2. Release the belt from the motor pulley.
3. Release the idler spring from the motor and lift the
assembly off the motor.

Removing the drive motor:

1. Disconnect the dryer from electrical supply and
remove the drum.
2. Unplug the harness from the motor and remove
the idler assembly.
3. Unscrew the blower wheel from motor shaft.
4. Release the front motor lock from the blower
housing.
5. Release the spring hold down on the rear of the
motor and lift the motor out.
Removing the burner: (Gas dryers)
1. Disconnect the dryer from electrical supply and
remove the front panel.
2. Unplug the igniter, remove the two screws holding
the burner to the valve assembly bracket, and slide
the burner into the combustion chamber to release
burner from the valve.
76
Spring
Hold
Down