Removing The Turn To Start Or Temperature Switch (Front Console Models); Removing The Press Saver Option Or End Of Cycle Chime Switch (Top Console Models) - Electrolux 27" Electric Dryers Service Manual

Removing the turn to start or temperature switch:
(Front console models)
1. Disconnect the dryer from electrical supply.
2. Remove the knob from the switch, lift the top,
disengage the front panel and lean it forward.
3. Disconnect the wires from switch.
4. The switch is held to control mounting panel by two
spring loaded ramping tabs and a locking tab.
5. Using a small screwdriver lift the locking tab, turn
the switch about 1/8 of a turn counter clockwise
and pull back on the switch.
Removing the press saver option or end of cycle
chime switch: (Top console models)
1. Disconnect the dryer from electrical supply.
2. Remove the knob from the switch and remove the
rear panel of the console.
3. Disconnect the wires from the switch.
4. The switch is held to the control mounting by a
spring loaded nut and a locking tab.
5. Using a small screwdriver push in on the locking
tab, turn the switch one half turn and pull it out the
rear.
63
Nut
Locking tab