Removing The Timer (Front Console Models); Removing The Turn To Start Or Temperature Switch (Top Console Models) - Electrolux 27" Electric Dryers Service Manual

Removing the timer: (Front console models)
1. Disconnect the dryer from electrical supply.
2. Remove the timer knob and raise the top panel.
3. Mark and disconnect the wires from the timer.
4. Remove the two screws holding timer to the con-
sole panel.
Removing the turn to start or temperature switch:
(Top console models)
1. Disconnect the dryer from electrical supply.
2. Remove the knob from the switch and the rear
panel from the console.
3. Disconnect the wires from the switch.
4. The switch is held to control mounting panel by two
spring loaded ramping tabs and a locking tab.
5. Using a small screwdriver lift the locking tab, turn
the switch about 1/8 of a turn counter clockwise
and pull back on the switch.
62