Drying Cycle Complete / Removing Laundry; Care And Cleaning; Cleaning Fluff Filter - Electrolux LAVATHERM 56840L User Manual

14

Care and cleaning

Drying cycle complete / removing laundry

Once the drying cycle is complete, display shows a blinking " 0 ". If the BUZZER button has
been pressed, an acoustic signal sounds intermittently for about one minute.
The drying cycles are automatically followed by an anti-crease phase which lasts around
30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose
and free of creases. The laundry can be removed at any time during the anti-crease phase.
(The laundry should be taken out towards the end of the anti-crease phase at the latest to
prevent creases from forming.) If LONG ANTI-CREASE function has been selected, the anti-
crease phase is lengthened by 60 minutes.
1. Open door.
2. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use
a damp hand for this purpose. (See "Care and cleaning" chapter.)
3. Remove laundry.
4. Turn the programme selector to OFF .
After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter "Care and cleaning".)
5. Close the door.
Care and cleaning

Cleaning fluff filter

The filters collect all the fluff which accumulates during drying. To ensure that the dryer
works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after
every drying cycle.
The warning led is on to remind you this operation.
CAUTION!
Never operate the dryer without fluff filters or with damaged or blocked fluff filters.
1. Open loading door
2. Use a damp hand to clean the micro-
fine filter, which is built into the lower
part of the loading aperture.