Removing The Idler Pulley; Removing The Idler Pulley Assembly; Removing The Drive Motor - Electrolux 6000 Service Manual

4. Remove (2) screws holding the housing to the dryer
base.
5. Remove the front motor lock by inserting a
screwdriver at the rear of the housing to release the
housing from the motor.
6. Raise the front of the motor and pull the housing
forward.

Removing the idler pulley:

1. Disconnect the dryer from electrical supply and
remove the rear access panel.
2. Release the belt from the motor pulley, remove the
"C" clip from the shaft and slide the idler pulley off.

Removing the idler pulley assembly:

1. Disconnect the dryer from electrical supply and
remove the rear access panel.
2. Release the belt from the motor pulley.
3. Release the idler spring from the motor and lift the
assembly off the motor.

Removing the drive motor:

1. Disconnect the dryer from electrical supply and
remove the drum.
2. Unplug the harness from the motor and remove the
idler assembly.
3. Unscrew the blower wheel from motor shaft.
77