Front Panel - Electrolux EIGD55H Technical & Service Manual

C C o o m m p p o o n n e e n n t t T T e e a a r r d d o o w w n n
F F r r o o n n t t P P a a n n e e l l R R e e m m o o v v a a l l
The front panel is secured with four screws, two
screws along the top edge and two along the
bottom edge. When removing the panel, use
caution not to strain the door switch electrical
leads.
To remove the front panel:
1. Remove the trim ring, door assembly and the
air duct cover.
2. Remove the top panel and console.
3. Using a #2 square bit screwdriver, extract
the two screws from the bottom of the front
panel, then the two screws at the top of the
front panel. (See Figure 4-18)
4. From the inside of the front panel, disconnect
the door switch electrical leads at the Molex
connector.
D D o o o o r r S S w w i i t t c c h h R R e e m m o o v v a a l l
The door switch is secured with retaining latches
to the backside of the front panel.
To remove the door switch:
1. Remove the trim ring, door assembly and the
air duct cover.
2. Remove the top panel, and console.
3. After extracting the screws securing the front
panel to the unit frame, reach behind the front
panel and disconnect the wire harness for the
door switch at the Molex connector. The front
panel can now be removed from the unit.
(See Figure 4-19)
4. Disconnect the wire leads connected to the
terminals of the door switch.
5. From the backside of the front panel, press in
the retaining latches while pushing door switch
through the front panel. (See Figure 4-19)
F F i i g g u u r r e e 4 4 - - 1 1 8 8 . .
Retaining
Latches
F F i i g g u u r r e e 4 4 - - 1 1 9 9 . .
4-8
Screws
Screws
Electrical
Connection