Accessibility Of Components; Door; Fluff Filter Fitted Inside Door; Fluff Filter Support - Electrolux EDR1000NEW Service Manual

13 ACCESSIBILITY OF COMPONENTS

If an electric screwdriver is used, ensure that the screws are not tightened excessively!

13.1 Door

a. To remove the door, remove the screws which secure it to the hinge.

13.1.1 Fluff filter fitted inside door

a. Lift out and clean at the end of each cycle.

13.1.2 Fluff filter support

a. Remove the two screws which secure the fluff filter support to the
inner door.

13.1.3 Lower fluff filter

a. E Remove by lifting from its seat.

13.1.4 Drum light (not all models)

The bulb can be replaced from inside the drum as follows:
a. Remove the two screws which secure the bulb cover and remove
the cover.
b. Unscrew the bulb from the bulb-holder.
c. When replacing the cover, ensure that the sealing ring is correctly
positioned in its seat.
N.B. Use only bulbs supplied as original spare parts (the code is
shown in the parts list for each model).

13.2 Work top

The following components can be accessed from the work top:
- Control panel support
Control panel
-
Electronic control units
-
- Front brush
a. To remove the work top, first remove the screws which secure the
top to the rear edge of the appliance.
b. Slide the top towards the rear.

13.2.1 Front brush of conductimetric sensor

a. Disconnect the connector.
b. Extract the brush from the seat in which it is fitted to the duct.
SOI/DT 2003-12 dmm 38/50 599 36 20-08