Section G - Teardown; Removing The Top Panel; Removing The Console - Electrolux 6000 Service Manual

SECTION G - TEARDOWN

This section will describe how to remove components
from both gas and electric dryers. Unless stated, the
procedure will be the same on all dryers. Unless stated,
reverse the procedure to reinstall the component.
Always remove electrical power from the
dryer when working in an area where electrical power is
present.
Always turn the gas off to the dryer before
opening any gas piping.

Removing the top panel:

1. The top panel is held in place in the front by (3)
plastic tabs on the console,
(2) metal tabs (one on each side),
and (2) screws In the rear.
2. Remove the (2) screws, slide the top back about
1/2 inch and lift the top off.

Removing the console:

1. Disconnect the dryer from electrical supply and
remove the top panel.
2. Remove the (4) screws, (2) on each side, holding the
console to the front panel and roll the console
forward.
65