Configuring Eternity Ne; Configuration Modes; System Engineer Mode; System Administrator Mode - Matrix ETERNITY NE System Manual

CHAPTER 4

Configuration Modes

ETERNITY NE can be configured at two levels: System Engineer and System Administrator.
A distinct set of features and facilities can configured at each of these levels.

System Engineer Mode

At the System Engineer level, the entire system configuration, all configurable features and facilities of the
ETERNITY NE can be changed as per end user requirements.
Only the System Engineer, the person who installs, configures and maintains the PBX must be allowed access to
this mode.
Access to the SE mode is protected by means of a password, referred throughout this document as the SE
Password.
SE Password
The SE password is a 4-digit code used to prevent unauthorized access and alterations or misuse of the features
and facilities. As this password is meant for restricting access to the SE mode, it must be kept strictly confidential
with the System Engineer. Default password:1234.
The SE password can be changed. Refer the topic
password.
If you forget the SE password, you can restore the default SE password. Read the topic
instructions on restoring the default SE password.
You are advised to record the SE password at a safe place, where it can be accessed by you (the System
Engineer) to avoid the inconvenience of restoring the default SE password.

System Administrator Mode

At the System Administrator level, the settings of the features for the Extension users can be changed, and various
system activity logs and reports such as fault log reports, Station Message Detail Recording reports, and system
reports, can be captured and printed.
Matrix ETERNITY NE System Manual

Configuring ETERNITY NE

"System Security" for instructions on how to change the SE
"Default Settings" for
51