Up Mode Settings For Wireless Lan - Ricoh D158 Service Manual


Make sure that the cables are not loose. Keep them wired tightly along the covers.

You may have to move the machine if the reception is not clear.

Make sure that the machine is not located near an appliance or any type of equipment
that generates strong magnetic fields.

Install the machine as close as possible to the access point.

UP Mode Settings for Wireless LAN

Enter the UP mode. Then do the procedure below to perform the initial interface settings for IEEE
802.11 a/b/g. These settings take effect every time the machine is powered on.

You cannot use the wireless LAN if you use Ethernet.
1. Press the [User Tools/Counter] key.
2. On the touch panel, press [System Settings].

The Network I/F (default: Ethernet) must be set for either Ethernet or wireless LAN.
3. Select [Interface Settings].
4. Press "Wireless LAN". Only the wireless LAN options show.
5. Press "Communication Mode". Select either "802.11 Ad-Hoc Mode", or "Infrastructure Mode".
6. Press "SSID Setting". Enter the SSID setting. (The setting is case sensitive.)
7. Press "Ad-HocChannel". You need this setting when Ad Hoc Mode is selected.
Region A (mainly Europe and Asia)
Range: 1-13, 36, 40, 44 and 48 channels (default: 11)
In some countries, only the following channels are available:
Range: 1-11 channels (default: 11)
Region B (mainly North America)
Range: 1-11, 36, 40, 44 and 48 channels (default: 11)
8. Press "Security Method".
9. Enter the "WEP (Encryption) Key.
10. Press "Ethernet Speed." Press the Next button to show more settings. Then select the
transmission speed.
11. Press "Return to Default" to initialize the wireless LAN settings.
D158/D159/D160/D161/D170 2-97
Controller Options
SM