Reassembling The Rear Scanner Wire - Ricoh D158 Service Manual

Scanner Unit (D158/D159)

Reassembling the Rear Scanner Wire

1. Pass the wire end with a ball (A) through the scanner drive pulley as shown below.
2. Position the center ball [A] in the middle of the forked holder.
3. Wind the end with the ring clockwise (shown from the machine's front) three times; wind the
ball end clockwise (shown from the machine's front) five times.

The two blue marks [A] should meet when you have done this.
D158/D159/D160/D161/D170 4-35 SM