Ricoh D158 Service Manual page 931

Communication Switch 10 (SP No. 1-104-017)
No Function
Memory transmission:
Maximum number of dialing
0-7
attempts to the same
destination
Communication Switch 12 (SP No. 1-104-019)
No Function
Memory transmission: Interval
0-7 between dialing attempts to
the same destination
Communication Switch 14 (SP No. 1-104-021)
No Function
Inch-to-mm conversion during
0 transmission
0: Disabled, 1: Enabled
Available unit of resolution in which fax
messages are received
Bit 7 Bit 6
6-7
0 0
0 1
1 0
1 1
SM
01 – FE (Hex) times
01 – FF (Hex) minutes
0: In immediate transmission, data
scanned in inch format are transmitted
without conversion.
In memory transmission, data stored in
the SAF memory in mm format are
transmitted without conversion.
Note: When storing the scanned data
into SAF memory, the fax unit always
converts the data into mm format.
1: The machine converts the scanned
data or stored data in the SAF memory
to the format which was specified in the
set-up protocol (DIS/NSF) before
transmission.
For the best performance, do not
change the factory settings.
Unit
The setting determined by these bits is
mm
informed to the transmitting terminal in
inch
the pre-message protocol exchange (in
mm and inch
the DIS/NSF frames).
Not used
89
Bit Switches - 3
Comments
Comments
Comments
D702