Ricoh D158 Service Manual page 867

Code Meaning
0-85 The line was disconnected
due to abnormal signaling in
V.34 control channel restart.
0-86 The line was disconnected
because the other terminal
requested a data rate using
MPh that was not available in
the currently selected symbol
rate.
0-87 The control channel started
after an unsuccessful primary
channel.
0-88 The line was disconnected
because PPR was
transmitted/received 9
(default) times within the
same ECM frame.
2-11 Only one V.21 connection flag
was received
2-12 Modem clock irregularity
2-13 Modem initialization error
2-22 Counter overflow error of
JBIG chip
2-23 JBIG compression or
reconstruction error
2-24 JBIG ASIC error
2-25 JBIG data reconstruction
error (BIH error)
2-26 JBIG data reconstruction
error (Float marker error)
SM
Suggested Cause/Action

The signal did not stop within 10 s.

Turn off the main power switch, then turn it
back on.

If the same error is frequent, replace the
FCU.

The other terminal was incompatible.

Ask the other party to contact the
manufacturer.

The receiving terminal restarted the
control channel because data reception in
the primary channel was not successful.

This does not result in an error
communication.

Try using a lower data rate at the start.

Try adjusting the cable equalizer setting.

Replace the FCU.

Replace the FCU.

Turn off the machine, then turn it back on.

Update the modem ROM.

Replace the FCU.
If error occurs frequently, change the settings
for resolution, paper size, compression type.
Turn off the machine, then turn it back on.

Turn off the machine, then turn it back on.

JBIG data error

Check the sender's JBIG function.

Update the FCU ROM.
25
Error Codes
D702