Ricoh D158 Service Manual page 906

Bit Switches - 1
No Function
Enable/disable for direct
sending selection
2
0: Direct sending off
1: Direct sending on
Action when the external
handset goes off-hook
3 0: Manual tx and rx operation
1: Memory tx and rx operation
(the display remains the same)
No
Country/area code for functional
settings (Hex)
00: France
01: Germany
02: UK
03: Italy
0 04: Austria
to 05: Belgium
7 06: Denmark
07: Finland
08: Ireland
09: Norway
0A: Sweden
0B: Switz.
0C: Portugal
D702
System Switch 0E (SP No. 1-101-015)
Direct sending cannot operate when the
capture function is on during sending. Setting
this switch to "1" enables direct sending
without capture.
Setting this switch to "0" masks the direct
sending function on the operation panel so
direct sending with ScanRouter cannot be
selected.
0: Manual tx is possible while the external
handset is off-hook. However, manual tx
during handset off-hook may not be sent to a
correct direction. Manual tx is not possible.
1: The display stays in standby mode even
when the external handset is used, so that
other people can use the machine for memory
tx operation. Note that manual tx and rx are
not possible with this setting.
System Switch 0F (SP No. 1-101-016)
Function
12: Asia
13: Japan
14: Hong Kong
15: South Africa
16: Australia
17: New Zealand
18: Singapore
19: Malaysia
1A: China
1B: Taiwan
1C: Korea
1D: Brazil
20: Turkey
Comments
Comments
This country/area code determines the
factory settings of bit switches and RAM
addresses. However, it has no effect on
the NCU parameter settings and
communication parameter RAM
addresses.
Cross reference
NCU country code:
SP No. 2-103-001 for G3-1
64 SM