Ricoh D158 Service Manual page 956

NCU Parameters
Address
68055A Break time (flash start mode)
International dial access code
68055B
(High)
International dial access code
68055C
(Low)
68055D PSTN access pause time
Progress tone detection level, and
68055E
cadence detection enable flags
68055F
To Not used
680564
680565 Long distance call prefix (HIGH)
680566 Long distance call prefix (LOW)
680567
to Not used
680571
Acceptable ringing signal
680572
frequency: range 1, upper limit
Acceptable ringing signal
680573
frequency: range 1, lower limit
Acceptable ringing signal
680574
frequency: range 2, upper limit
D702
Function Unit
The OHDI relay is open
1 ms
for this interval.
For a code of 100:
BCD 68055B - F1
68055C - 00
This time is waited for
each pause input after
the PSTN access code.
If this address contains
20 ms FF[H], the pause time
stored in address
68054F is used.
Do not set a number
more than 7 in the UK.
Bit 7: 0, Bit 6: 0, Bit 5: 0 = -25.0 dBm
Bit 7: 0, Bit 6: 0, Bit 5: 1 = -35.0 dBm
Bit 7: 0, Bit 6: 1, Bit 5: 0 = -30.0 dBm
Bit 7: 1, Bit 6: 0, Bit 5: 0 = -40.0 dBm
Bit 7: 1, Bit 6: 1, Bit 5: 0 = -49.0 dBm
Bits 2, 0 - See Note 2.
Do not change the
-
settings.
BCD For a code of 0:
680565 – FF
BCD
680566 - FF
Do not change the
-
settings.
SP2-103-003
(parameter 02).
1000/ N SP2-103-004
(Hz). (parameter 03).
SP2-103-005
(parameter 04).
114
Remarks
SM