Firmware Update Error - Ricoh D158 Service Manual

Firmware Update
ROM/NEW
ROM:
NEW:

Controller, engine and operation panel firmware cannot be updated at the same time.
It is recommended to update firmware modules one by one.
8. Touch "UpDate (#)" to start the update.

The progress bar appears on the operation panel.
9. The "Update is Done" message appears on the operation panel after completing the updating.
The message differs depending on the firmware that has been updated.
10. Switch the machine main power switch off when you see the "Update is Done" message or
follow the procedure that is displayed on the operation panel.
11. Press in the SD card to release it. Then remove it from the slot.
12. Switch the machine on for normal operation.

Firmware Update Error

If firmware update fails, an error code appears.
The following example (E36) reports that the program which you wish to update is not in the
machine or the data in the machine you wish to update does not correspond to the data in the
card.
D158/D159/D160/D161/D170
Tells you the number of the module and name of the version
currently installed. The first line is the module number, the
second line the version name.
Tells you the number of the module and name version on the
SD card. The first line is the module number, the second line
the version name.
What it means
6-4 SM