Taking A Series Of Pictures (Continuous Shooting/Burst Shooting) - Ricoh WG-20 Operating Manual

5
Press the shutter release button fully.
Countdown starts and the remaining seconds are displayed on the screen.
If you select g
The self timer lamp and all of the macro lights turn on.
From 4 seconds before shooting, the macro lights turn off in order
from the top right.
From 3 seconds before shooting, the self timer lamp also blinks.
If you select Z
The self timer lamp and the macro lights blink.
The picture is taken after a countdown of either ten seconds or two seconds.
Focusing may be compromised if you move the camera while the self-
timer lamp is blinking when taking still pictures.
• In C (Movie) and
after ten seconds (or two seconds).
• Press the shutter release button halfway while the self-timer is engaged
to stop the countdown and press fully to restart the countdown.
• Z cannot be selected while 9 (Green) mode is in default setting.
Select Z in another shooting mode and then switch the shooting
mode to 9.
• The self-timer lamp does not flash in e (Pet) mode.
• In the following situations, the macro lights remain turned on
regardless of the countdown.
- In the Digital Microscope mode
- When [Macro Light] on the [A Rec. Mode] menu is set to O (On)
Taking a Series of Pictures (Continuous Shooting/
Burst Shooting)
Pictures are taken continuously as long as the shutter release button
is pressed.
Continuous
j
Shooting
Burst
c
Shooting
* The number of images that can be shot continuously and the interval between
shots depend on shooting situations.
(Underwater Movie) modes, recording will start
Each time a picture is taken, the image is saved in the memory
before the next image is taken. The higher the image quality,
the longer the interval between shots.
The number of recorded pixels is fixed at f (2592×1944)/
(2592×1464) and the interval between shots is shorter
than "Continuous Shooting".
3
95