Changing The Start-Up Screen - Ricoh WG-20 Operating Manual

Changing the Start-up Screen

You can choose the start-up screen displayed when the camera
is turned on.
You can choose any of the following images as the start-up screen:
• The Guide Display Start-up Screen showing a guide to the shooting
modes and buttons
• The pre-installed screen
• One of your own images (compatible images only)
1
In Q mode, press the four-way controller (3).
The Playback Mode Palette appears.
2
Use the four-way controller
(2345) to select
(Start-up Screen).
3
Press the 4 button.
The image selection screen appears.
4
7 Use the four-way controller
(45) to choose the image
for the start-up screen.
Only images suitable for the start-up
screen are displayed. You can also
choose the pre-installed screen
or the Guide Display Start-up Screen
already stored in the camera.
5
Press the 4 button.
The setting is saved.
238
Start-up Screen
F o r s e t t i n g a c a p t u r e d
i m a g e a s t h e S t a r t - u p
S c r e e n
MENU Cancel
MENU MENU MEN Cancel Cancel Cancel
2 / 2
OK OK
100 - 0017 10 100 - 001
0017
OK OK OK OK OK