Taking Pictures At A Set Interval (Interval Shoot) - Ricoh WG-20 Operating Manual

Taking Pictures at a Set Interval (Interval Shoot)

In this mode, a set number of pictures can be taken automatically at a set
interval from a set time.
Interval 10 sec. – 99 min.
Number 2 shots – number of
of Shots recordable images
Start Delay 0 min. – 24 hours
1
Press the four-way controller (2) in A mode.
The [Drive Mode] screen appears.
2
Use the four-way controller (45)
to select k (Interval Shoot)
and press the 4 button.
The current interval shoot settings
appear for approximately 1 minute.
To take pictures with the current
settings, go to step 10.
3
Press the 4 button while the settings are displayed.
The [Interval Shoot] setting screen appears. [Interval] is marked with
the frame.
4
Set the interval.
1 Press the four-way controller (5).
2 Use the four-way controller (23)
to set the minutes, then press
the four-way controller (5).
3 Use the four-way controller (23)
to set the seconds, then press the four-way controller (5).
The frame returns to [Interval].
5
Press the four-way controller (3).
The frame moves to [Number of Shots].
Set the camera to take pictures at intervals.
The intervals can be set in increments of one second
from ten seconds to 4 minutes, or in 1 minute
increments from 4 to 99 minutes. You cannot set the
camera to take interval shots at less than ten seconds.
You can set this to up to 1000 shots. However,
it cannot exceed the number of recordable images.
You can set 1 minute increments for the first
59 minutes and 1 hour increments from there. If the
start time is set to 0 minutes, the first picture is taken
as soon as the shutter release button is pressed.
Drive Mode Drive Mode Drive Mode
Interval Shoot Interval Shoot Interval Shoot
Cancel Cancel Cancel
MENU MENU MENU
Interval Shoot
Interval
Number of Shots
Start Delay
MENU
3
OK OK OK
OK OK OK
0 10
min. sec.
2
0 0
hr. min.
99