Installing The Sd Memory Card - Ricoh WG-20 Operating Manual

Installing the SD Memory Card

This camera uses SD Memory Cards, SDHC Memory Cards or SDXC
Memory Cards. (These cards are referred to as SD Memory Cards
1
hereafter.) Captured images and sound files are saved on the SD
Memory Card if a card is inserted in the camera. They are saved
in the built-in memory if a card is not inserted (p.43).
• Be sure to use this camera to format (initialize) an SD Memory
Card that is unused or has been used on other cameras or digital
devices. Refer to "Formatting the Memory" (p.214) for instructions
on formatting.
• Make sure that the camera is turned off before inserting or removing
the SD Memory Card.
• Allow the camera to dry completely before changing the SD Memory
Card. Avoid changing the card where the camera is likely to get wet
or dirty, and make sure that your hands are dry.
• Do not use excessive force when sliding the battery/card cover open
and closed because the waterproof packing may peel off. If the
packing is not in the correct position, the camera will not be waterproof.
• The still picture storage capacity varies depending on the capacity
of the SD Memory Card and the selected number of recorded pixels
and quality level (p.272).
• The power lamp blinks while the SD Memory Card is being accessed
(data is being recorded or read).
Backing Up Data
The camera may not be able to access data in the built-in memory in the case
of a malfunction. Use a computer or other device to back up important data
in another location.
40